Ammo can power supply. (Part 4)

Read part 1 here , part 2 here , part 3 here , part 4 here or part 5 here.


 After the bit too long break we'll continue building the power supply. Plan vas to do the ventilation grills to make sure air flows around and keeps everything cool.

Places for holes are measured to match the heatsink and to the spot where there is very little all kind of stuff around it. I chose to put intake grills to the lower front corner so air flows over the transformeer to back and through the heatsink.

 Draw the grills where you want them to be and pic up the Dremel. Use the cut off wheel to follow lines. You can ofc replace lines with holes if you want / don't have dremel. Another choice is to remove the whole square and put some ready grill on the inside.

Bit of paint and it looks much better.

Color is green camo paint from  Motonet.

On the next part we'll put all the stuff inside and make sure everything works.